Introduction: Guitar Amp Music Light

Picture of Guitar Amp Music Light

This is the finished product.

Step 1: The Stuff You Need

Picture of The Stuff You Need

1. guitar amp
2. a computer cold cathode lighting with microphone
3. soldering gun with solder 
4. hot glue gun with hot glue stick 
5. wire stripier/cuter  
6. screwdriver

Step 2: First

Picture of First

Unplug your guitar amp then, open your guitar amp with your screwdriver. 

Step 3: Then

Picture of Then

Cut off the plug that leads to the power supply then strip the wire that leads to the microphone.  

Step 4: Guess

Picture of Guess

Guess where the power is on the amp circuit bored with the wires you striped touch a different little solider bumps with each wire. Well the amp is plunged in (don't shock your self). Ones the light turns on you know where to solider the wires.        

Step 5: Finally

Picture of Finally

Close the amp and slip the wires with the light and microphone out.(you might have to make your on slit for the wires.)   

Step 6: Glue

Picture of Glue

Glue the microphone and light where you wish. 

Step 7: Test

Picture of Test

test out the light to see if it worked. 

Comments

robot797 (author)2011-07-04

if you want i have a circut that makes it move as an equilizer
do you want that?

Preston .s (author)robot7972011-07-04

i already have that but thanks.

robot797 (author)Preston .s2011-07-04

a real working equlizer
realy
nize
i though those tubes had a music blink only
(blinking on and off on the music)

Preston .s (author)robot7972011-07-05

it has a very slight movement of going from one side to another.

robot797 (author)Preston .s2011-07-05

mmmmm
http://www.youtube.com/watch?v=nF86E0SvBq8
look at this

Preston .s (author)robot7972011-07-05

that's what it dose

About This Instructable

3,193views

13favorites

License:

More by Preston .s:Make Bow Tie Guitar amp music light
Add instructable to: