The spacing of the 2 gears that make up the repeater mechanism at the heart of this gun was adapted from MrRadicalEd's RBG Repeater, because it's so simple and works better than all the more complicated ones I've made or tried.
Picture 1: Complete "Gunzo The Great"
Pictures 2&3: Shows my adaptation of MrRadicalEd's 2 gears. (just a model demonstrating the size and relative positioning of the gears)
Thanks to MASTERMIND for the piece count:
6 white connectors (8-way)
38 yellow connectors (5-way)
6 green connectors (4-way)
20 red connectors (3-way)
4 light gray connectors (2-way)
2 dark gray connectors (1-way)
2 blue tabless (or tan tabbed) clip connectors
97 green rods
34 white rods
9 blue rods
7 blue spacers
Step 1: The Gun Sides
Note, the Red Connector in the middle is missing in a few of the later pictures. That was a mistake. It is always supposed to be there.
Step 2: Trigger And Spinner Wheel
Picture 2: spinner wheel
Step 4: Handle Pieces & odd parts
Pic 2: Make 2 of these. We'll call these "Handle Spacers"
Pic 3: Make 1 of each of these. They are the "Red Handle Base" and the "Yellow Handle Base"
Pic 4: These are called "Through Rods" or Thru-rods. (All Orange connectors are temporary)
Pic 5: These are Side Clips. You'll actually need to take the grey connector off of the white Snowflake connectors, and replace them at the end of step 9.