Instructables

HOT ROD FLAMES PAINT AND MASK

Picture of HOT ROD FLAMES PAINT AND MASK

THIS IS A QUICKIE ON HOW I PAINTED WOODEN DOORS FOR A SHOP
 
Remove these adsRemove these ads by Signing Up

Step 1:

Picture of
FLAME3SUPPLIESPIC.jpg
FLAME4WAXPAPER copy.jpg

Step 2: SUPPLES AND REFENCE DRAWING

Picture of SUPPLES AND REFENCE DRAWING

Step 3:

Picture of

Step 4: CUTTING MASK

Picture of CUTTING MASK
FLAME6WEEDING.jpg
FLAME6WEEDING.jpg
TAKE YOUR TIME AND USE A SOFT TOUCH AS NOT TO LEAVE A DEEP CUT ON THE FINISHED PRODUCT,

Step 5: WEEDING

Picture of WEEDING
DSCN1159.JPG

Step 6: MASK READY FOR PAINT

Picture of MASK READY FOR PAINT
FLAMEMASKREMOVING.jpg
THE BOARD HAD RED PAINT ON IT TO START, THIS WAS PAINTED OVER THEN ORANGE USED FINALLY YELLOW

Step 7: PAINTING

Picture of PAINTING
FLAMEMASKREMOVING.jpg

Step 8: REMOVING MASK

Picture of REMOVING MASK
PULL AWAY FROM PAINT EDGE, HELPS KEEP PAINT FROM COMING UP AS WELL

Step 9: FINAL

Picture of FINAL
IMAG0218.jpg
DSCN1159.JPG
WILL PINSTRIPE PROBABLY... NOT SURE ANY THOUGHTS.



TRIED TO ADD FINAL PICS THEY ARE NOT THAT BAD....