Print PDF
Favorite
Email
Step 2Locate the parts and trace
Remove the lid from the toilet tank. Locate the over flow tube, gently remove the rubber tube going into the top of it. Take the small plastic funnel and stick it in the tube. Now take a straight edge and span it across the walls of the tank next to the funnel, and mark the edge on the funnel. Now remove the funnel and lay a piece of paper of the tank and trace out the walls and the location of the over flow pipe in relation to them. Next take the lid from the tank and trace it onto the sheet wood.
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
10
Aug 18, 2011. 6:51 PMjj.inc
says:
I was sitting here trying to figure out how this fills the tank, I thought it would just dump all the water into the bowl then I saw this for like the fifth time and was like duh. The thing has two water outputs, one for the bowl, and one for the tank. Yay, I wan't to make one.
Reply
 |
Add Comment
|
