Print PDF
Favorite
Email
Step 29Y signal
Now solder a wire to this spot to access the Y-signal. Affis this to pin 2 of the chip.
See pic 2: Remember to keep this wire out of that lil white circle.
See pic 2: Remember to keep this wire out of that lil white circle.
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
Aug 5, 2007. 7:06 PMoneeyedlizzard
says:
I think it is a little easier to solder X to the resistor left of where you solder Y. It works just as fine and you don't have to use all that flux.
Reply
32
Aug 6, 2007. 2:27 AMklee27x (author)
says:
The resistor to the left of Y is the B trace! At least on this pcb!
Reply
Aug 6, 2007. 10:05 PMoneeyedlizzard
says:
Dammit, i meant right, I got mine together and it double shots so i know one of them is x.
Reply
32
Aug 7, 2007. 1:15 AMklee27x (author)
says:
ahh kewl. I hope other people are reading this and can figure that part out. I had no idea that the X was accesible there. I guess I missed that one. Thx.
Reply
 |
Add Comment
|
