Step 4: Making the parts
Each part is designed to be milled out of 3/4" stock.
Design the mill paths based on the 3D models by opening the files in Mastercam and adding support geometry.
Mill multiple sets of the supports, as these parts are struck by the bow limb during firing and can fail over time.
Design the mill paths based on the 3D models by opening the files in Mastercam and adding support geometry.
Mill multiple sets of the supports, as these parts are struck by the bow limb during firing and can fail over time.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
Visit Our Store »
Go Pro Today »
