Print PDF
Favorite
Email
Step 6Now for some hacking.
Solder a piece of long wire on to the terminals shown in the picture.(sorry for a blurry picture) This is the wire to be connected to the amplifier.
Note: The thinner the wires are, the better, because the head will have space to move around and will not be resisted by the wire.
Note: The thinner the wires are, the better, because the head will have space to move around and will not be resisted by the wire.
| « Previous Step | Download PDFView All Steps | Next Step » |
2
comments
|
Add Comment
|
Jan 2, 2011. 12:45 AMPyrice4
says:
You can follow these two all the way through the ribbon wire into the back of the main PCB so you dont have to take the arm off.
Reply
Feb 20, 2011. 2:58 PMMoglizorz
says:
Yea, that's what I'm doing now. Seems alot easier soldering to the existing PCB (especially on this old 90's hard drive I'm using where the components are massive) than doing this delicate stuff.
Reply
 |
Add Comment
|
