Harry Potter Sorting Hat With Arduino

1,124

10

1

Published

Introduction: Harry Potter Sorting Hat With Arduino

This is a simple arduino project on how to make a sorting hat from the Harry Potter franchise which will sort you into a house with the help of lights, controlled by an arduino.

Good luck making it!

Step 1: Step 1: Materials

You will need:

- an Arduino Uno
- a red led
- a blue led
- a green led
- a yellow led
- 5x 220 ohm resistors
- a button
- 7x jumper wires
- a breadboard
- a hat
- 3x socks
- a powerbank
- needle and thread

Step 2: Step 2: the Build

Every LED should be connected with a resistor from pin 2 to pin 10.

Connect the ground GND pin to the ground rail of the breadboard and connect the button to the 5v and the analog ground GND pin.

Rebuid this circuit with your own arduino.

Sew 1 sock to the back of the hat to put the powerbank in and 2 underneath the hat to put the arduino and breadbord in.

Step 3: Step 3: the Software

Download the file and load it.

Have fun :D

Share

    Recommendations

    • Clocks Contest

      Clocks Contest
    • Planter Challenge

      Planter Challenge
    • Casting Contest

      Casting Contest
    user

    We have a be nice policy.
    Please be positive and constructive.

    Tips

    Questions

    Comments

    That's a fun mod!