Print PDF
Favorite
Email
Step 6Soldering the IC socket
The purpose of this socket is to allow you to change op-amps without the need to solder, it also prevents the amp from getting hot and damaged during soldering by eliminating the need to solder it on the board
NOTE: the orientation of the ic socket, notch towards the bottom.
the images below show where the legs should sit, however we will not solder the other components till the next step.
NOTE: the orientation of the ic socket, notch towards the bottom.
the images below show where the legs should sit, however we will not solder the other components till the next step.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
