Headphone Amp (Chu Moy)

Step 8 Adding the jacks and volume control

First step is to solder wire to all the pins of the headphone jacks, about 2 inches long. once this is done we can solder up the potentiometer (these are not connected to the amp till later so you dont need to worry about layout, just solder a length of wire to each of the jack pins and for the pot, see the image below)
your jacks layout may differ, however it usually goes from top (closes to the hole) to the bottom
Ground right left .

Note: i means input. so il ir and ig mean Input left input right and input ground, these abbreviations match that of the final layout diagram on the next page