Very nice project, thanks for sharing. I actually have a customer to whom I suggested this basic idea to, they want to hide a gun safe and have a very basic panic room at reasonable cost. I found your project while searching for ideas. I need a nice locking mechanism, that is hidden and or remote controlled that would work if power was off. I am thinking simple slide bolts on inside to secure once inside, but need something more solid than magnetic catch for keeping it closed, this will be in a large (16x24) red cedar walk-in closet so "bookcase" will probably have sweaters or linens in it . Have plenty of woodworking tools and knowledge but still puzzled on lock. Any ideas would be welcomed. I need the ideas fairly fast if possible. Thanks in advance. Again very neat project and thanks for sharing. Randy
How about running a cable from a lock to underneath one of the lower shelves(not too low) you could attach a hand grab to pull that would pull the cable and thusly open a latch. You could install other additional locks inside so that a would be attacker couldn't get in if he happened to find the cable pull.
Randy, Thanks for the kind words. I think the basic idea could be easily modified to be a safe room door. It will absolutely support the weight of steel or cement. Lots of folks below have suggested ideas for “hidden latches”.
As to a reliable, easy, convenient, and undetectable lock mechanism: My favorite idea is a variation of the magnetic latches they sell in the baby proofing section. A strong latch is located behind a panel. This latch is released by placing a powerful magnet on the outside of the panel. In practice this would be a “paperweight” that is sitting on the shelf. By placing this paperweight in the right spot on the shelf, the latch is released, and the door can be opened and closed freely. If the weight is moved, the door latches when closed. To work the latch must have a slight bit of free play, so I would include a light magnetic stop to keep the door from being able to rattle against the latch ( not that 300 pound doors rattle much) and it would also keep the door in position to allow smooth release of the latch( an almost balanced mechanism with strong magnet mounted on pull part.
great post. I have been wanting to do this with the closet/pipe access to the bathroom door in our den. It's ugly and we need more bookshelves. Unfortunately, there's not enough room on the one side of the door to do a full bookshelf so it would have to have some sort of ornamental dohickey or slide to the side instead of outward on rails that are hidden under and over the shelves when the shelves are in place. Really cool project!
If you cut the crown on a bevel, you might be able to hide the edges better. Plus, the wood will add just a little bit more backstop to prevent the door from going too far back. (It's just a little more insurance. It will not replace the backstop you already have in.) This is a very nice project. Thank you for sharing. (Now I need to figure out where I can put one.)
hi, since i'm not a paying member on instructables i can't download the plans... Can I find them elsewhere or would you mail them to me... i'm considering of making an automated version of this hidden bookshelf.
I had a friend who built a bookshelf to conceal a secret closet. He installed an electric locking device (electro magnet) to hold the bookshelf closed until a certain light switch was activated.
If you added a way to "lock" it from the inside of the storage room, it could be used as a kind of poor man's panic room. You could keep some water, a charged cell phone and whatever else you deem necessary. Of course you would need to sound proof the storage room somewhat if you want to be able to call for help on the cell phone. I don't think reception would be a problem in this case as you said it's under the garage, but you could run some kind of wire out to be able to increase your bars.
i think you are rite he does need a locking mechanisim, might i sugest a method i saw where u put a small hole in one of the side shelves and put something like a deadbolt bolt thing on the door shelf thing andthen when when uclose the bookshelf the bolt will lock so when u put a small piece of wire in the hole it will unlock the bookshelf by pushing in the bolt thus opening the bookshelf
I'm in awe! I think my jaw just unhinged.. Only thing I could spot it not beeing so secret, is it seems that the bookshelf-door is a bit shalower than the two others.. Looks a bit brighter too, but that could be shadows though.. But hey man, smooth welding and setup. You rock!
I'll build something like this one day... It could have been more subtile if the shelfs on the secret doors had been placed on the same level than the real shelves.
Randy
Thanks for the kind words.
I think the basic idea could be easily modified to be a safe room door. It will absolutely support the weight of steel or cement.
Lots of folks below have suggested ideas for “hidden latches”.
As to a reliable, easy, convenient, and undetectable lock mechanism: My favorite idea is a variation of the magnetic latches they sell in the baby proofing section. A strong latch is located behind a panel. This latch is released by placing a powerful magnet on the outside of the panel. In practice this would be a “paperweight” that is sitting on the shelf. By placing this paperweight in the right spot on the shelf, the latch is released, and the door can be opened and closed freely. If the weight is moved, the door latches when closed. To work the latch must have a slight bit of free play, so I would include a light magnetic stop to keep the door from being able to rattle against the latch ( not that 300 pound doors rattle much) and it would also keep the door in position to allow smooth release of the latch( an almost balanced mechanism with strong magnet mounted on pull part.
I think I might have to try this:)
could be used as a kind of poor man's panic room. You could keep some water, a charged cell phone and whatever else you deem necessary. Of course you would need to sound proof the storage room somewhat if you want to be able to call for help on the cell phone. I don't think reception would be a problem in this case as you said it's under the garage, but you could run some kind of wire out to be able to increase your bars.
But hey man, smooth welding and setup. You rock!
I'll build something like this one day...
It could have been more subtile if the shelfs on the secret doors had been placed on the same level than the real shelves.