Step 5: Load and Fire!
You will need to get some Flash Cotton, Flash Paper and Flame Resistant Confetti. You can get these at Magic Shops or online.
1. Put the Cannon either outside or indoors in a safe place like a large room with high ceilings or auditorium. You will have to clean up alot of confetti so keep that in mind.
2. Tear off a small piece (about 2" square) of Flash Cotton and fluff it up. Insert it in the Tower and push it all the way down. Be careful not to damage the Glow-Plug end as it is a bit fragile.
3. Use one sheet of Flash Paper and ball it up small enough to fit in the tower. Push it into the Tower all the way to the bottom. Don't stuff it in hard!
4. Load the Tower with Flame Resistant Confetti.
5. STAND BACK!!!
6. Press the Detonator switch!
Hope you enjoyed this Instructable.
Have fun, be safe!
1. Put the Cannon either outside or indoors in a safe place like a large room with high ceilings or auditorium. You will have to clean up alot of confetti so keep that in mind.
2. Tear off a small piece (about 2" square) of Flash Cotton and fluff it up. Insert it in the Tower and push it all the way down. Be careful not to damage the Glow-Plug end as it is a bit fragile.
3. Use one sheet of Flash Paper and ball it up small enough to fit in the tower. Push it into the Tower all the way to the bottom. Don't stuff it in hard!
4. Load the Tower with Flame Resistant Confetti.
5. STAND BACK!!!
6. Press the Detonator switch!
Hope you enjoyed this Instructable.
Have fun, be safe!
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
vandal1138
says:
Jul 2, 2009. 1:24 AMReply
any tips on how to make a much larger, shoulder launched version? I'm serious...
Visit Our Store »
Go Pro Today »
