Print PDF
Favorite
Email
Step 4Expo
Make some measurements, and cut the expo maker at the correct spot.
**make sure to use the side of the marker that is thiner**
Apply the thread seal tape on the end of the expo maker you will put into the flash light. Shove the marker into the end of the body. Use the pipe tape and seal the expo maker to the flash light.
Then, get the tail and apply the thread seal tape on the tail. you can screw the tail into the expo maker. Then use the pipe tape to seat the tail to the expo maker.
**make sure to use the side of the marker that is thiner**
Apply the thread seal tape on the end of the expo maker you will put into the flash light. Shove the marker into the end of the body. Use the pipe tape and seal the expo maker to the flash light.
Then, get the tail and apply the thread seal tape on the tail. you can screw the tail into the expo maker. Then use the pipe tape to seat the tail to the expo maker.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
