Print PDF
Favorite
Email
Step 10A Different Material
After I built this boot brush, I reasoned that plywood would not hold up very well outside, so I built a second boot brush out of 7/16" HDPE plastic.
The changes I made were:
- I used 1" wood screws (3/32" pilot hole) instead of 2"
- I ended up counter sinking the wood screws because the plastic started splitting as the head drove into the plastic. See second picture in this step.
The changes I made were:
- I used 1" wood screws (3/32" pilot hole) instead of 2"
- I ended up counter sinking the wood screws because the plastic started splitting as the head drove into the plastic. See second picture in this step.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
