Introduction: Horseshoe Drink Stand
I built this to put between lounge chairs to hold cans or bottles.
Step 1: Stand
I used an old throwing horseshoe for the stand
Step 2: Flat Bar
Welded a piece of flat bar to stand so the round bar had a place to go.
Step 3: Round Bar
Added the round bar for the stand.
Step 4: Horseshoes
Welded 2 horseshoes upside down with a thin plate in the middle to separate cans or bottles.
Step 5: Top of Stand
Plate on top of pipe to hold the drinks. 2 pieces of flat bar on each end to separate the horseshoes from the plate.
Step 6: Prime & Paint
Stand is 25 and half inches tall. Drink holders are 4 inches deep. Works perfect.