Print PDF
Favorite
Email
Step 2Hole Drilling
There are only three required holes.
I used a hot soldering iron to melt through my cutting board.
The middle hole has a 3mm hole drilled through and a 15 mm wide and 5mm deep depresion made around it. (this depression is to allow the bolt holding the bottom of the hotwire to rest flush with the cutting boards surface)
Below is a picture showing the hole layout.
I used a hot soldering iron to melt through my cutting board.
The middle hole has a 3mm hole drilled through and a 15 mm wide and 5mm deep depresion made around it. (this depression is to allow the bolt holding the bottom of the hotwire to rest flush with the cutting boards surface)
Below is a picture showing the hole layout.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
