Print PDF
Favorite
Email
Step 2Tools and supplies
You might be able to do the whole project with just a knife, a drill and some tape, but it would be better to have the following:
1. Utility knife
2. Small wood saw
3. Drill with a bit slightly bigger than the #10 screws
4. Screwdriver
5. A couple of cable ties or twist ties
6. Electrical tape
7. Wide packaging tape
8. Nibbler
9. Multitester (you don't NEED one but it's a good safety check)
10. Wrench to match the nuts (I didn't have my SAE wrenches handy so I used a 9mm)
11. Solder and soldering iron, if you like
1. Utility knife
2. Small wood saw
3. Drill with a bit slightly bigger than the #10 screws
4. Screwdriver
5. A couple of cable ties or twist ties
6. Electrical tape
7. Wide packaging tape
8. Nibbler
9. Multitester (you don't NEED one but it's a good safety check)
10. Wrench to match the nuts (I didn't have my SAE wrenches handy so I used a 9mm)
11. Solder and soldering iron, if you like
| « Previous Step | Download PDFView All Steps | Next Step » |
2
comments
|
Add Comment
|
1
Nov 27, 2009. 8:39 PMEvilthingamabober
says:
Umm, I have a nibbler from Futurama, will that do?
Reply
Sep 7, 2010. 4:01 AMgiventake65
says:
what is the use of a nibbler in this project?
Reply
 |
Add Comment
|
