Instructables

How To Add a Steel Coupling to a Hand Rail

video How To Add a Steel Coupling to a Hand Rail
Apparently... Shipping an 11' hand rail is VERY expensive. So when Scott Shaeffer of San Juan Carpentry was faced with the challenge to save his customer hundreds of dollars, he cut his piece of work in half! Then put it all back together again with a stylish steel coupling. Give it a try!
mrbybee2 years ago
Great work, I like how it looks with the bark still left on. During your video I was wondering if you could have just cut it in half, then used the hole saw (the second one you used) to make it possible to insert the pipe inside the handrail so all you would see was the natural wood. Would something like that work and still add enough strength?
I did this recently using a 6" piece of 1" steam pipe hidden inside, it lined up almost perfectly and just needed a tickle with a file so that the joint was almost invisible, its easier than you think.
San Juan Carpentry (author)  mrbybee2 years ago
That's the same question my wife asked me! And I did think about doing that but the reason I didn't do it was because if the pipe didn't go into each end exactly straight and centered, the railing would bend and you wouldn't get the butt ends to fit flush or center. Of course you could sand the ends until they did fit flush but then you'd lose more log and there'd still be a seam that wouldn't really maintain visual continuity. That's my theory anyway, and that's why I didn't do it.

What I would have liked to do differently was find a pipe and log that were closer in width so that the coupled ends wouldn't taper so much but since the railing was already complete, and pipe comes in standard sizes, I had no choice. Thanks for the comment!