Introduction: How to Make 9v Battery Case With a Switch

Picture of How to Make 9v Battery Case With a Switch

Step 1: Things You Need

Picture of Things You Need

1)9v connector and battery 
2) Plastic box ( i used a paper clip box)
soldering rod and wire
hot glue gun 
cutter or knife
wire stripper

Step 2: Cutting the Box

Picture of Cutting the Box

now you have cut a square in 1 corner of the box and make sure that your switch fits inside it.

Step 3: Soldering Together

Picture of Soldering Together

Now its time to solder the switch to the 9v battery and wires.
solder the positive wire with the switch.
now make two holes in the same side of the switch  in which your wires can easily go through .

Step 4: Assembling It Together

Picture of Assembling It Together


RIGSAW Developments (author)2013-12-29

Looking good mate :)

About This Instructable



Bio: I was 13 when I made this account so please don't make fun of my username
More by Pranavthegreat:How To Make A Dark SensorHow to program attiny using arduino unocontrol your servo using a 555 timer!!!!!!!!!!!!!!!!!!!!!!!!!!
Add instructable to: