Introduction: How to Make a Diamond Rainbow Loom

Step 1: Step 1

Start by putting the first band on the first band going diagonally left.

Step 2: Step 2

Do the same as step one but diagonally right starting on the first pin.

Step 3: Step 3

On top of the second left pin, add another band going diagonally right... As the same as the second right pin going left diagonally!

Step 4: Step 4

Keep doing that pattern to the top. You will end with one last ban on top.

Step 5: Looping: Step 1

Flip the loom so the arrows are pointing at you and always use the looping tool.

Step 6: Step 2

Grab the top orange band and flip over to the left pin.

Step 7: Step 3

Grab the remaining orange band and flip over to the right pin.

Step 8: Step 4

Grab the yellow band on the left pin and flip to the center pin.

Step 9: Step 5

Grab the remaining yellow band and flip over to the center pin. Now there should be two bands on the center pin.

Step 10: Step 6

Continue looping the yellow and orange bands until you've reached the last set of bands!

Step 11: Last Step 10

To add a c clip put the loop tool through the entire top part of the bands by the top pin and pull the bracelet of the loom. Now just add the c clip on one end and attaché to the other! There you go! You made a diamond bracelet.

Comments

author
chonison (author)2014-10-25

Try this out! Sorry for the bad explanation. It was my first upload...

author
eddiengmc made it! (author)2014-10-06

www.trendxloom.com

01.jpg
author
eddiengmc made it! (author)2014-10-06

Check this Diamond Bracelet made using TRENDXLOOM Silicone Loom Bands Colours!

http://www.trendxloom.com/#!Diamond-Loom-Bracelet-Easy-effective-mesmerizing-and-captivating-Loom-style-bracelet/c10j/7D4F5901-4E1C-4EC3-BDDE-A26B255FCBDD

01.jpg
author
chonison (author)2014-01-05

Thanks for looking at my Rainbow Loom tutorial! make sure you comment!

About This Instructable

22,335views

4favorites

License:

More by chonison:How To Make A Diamond Rainbow Loom
Add instructable to: