This is a simple and quick task to do

Step 1: Materials

Beer bottle
Lighter fluid
Ice cold water

Step 2:

Tie string tight on bottle

Step 3:

Take string off bottle

Step 4:

Pore the lighter fluid in a glass

Step 5:

Soak string in glass that has lighter fluid

Step 6:

Light the string after you put it back on the glass

Step 7:

Hold over sink and twist bottle until fire dies down

Step 8:

Pore cold water on bottle

Step 9:

This is the fire when its going down

Step 10:

Sand the edge then your done
<p>Great idea! I've never seen it done this way before. Do you get a cleaner break than using a glass cutter?</p>
<p>yes just make sure that the string Is on the bottle straight and it should come out pretty straight. </p>
<p>Another thing you can use other than lighter fluid is acetone nail polish remover :). I'm not sure if non-acetone remover would work but they are both highly flammable. When I made these I found that it was eaisier filling my sink with ice cold water and dipping the bottles in. Great ible!</p>
<p>yes all of those can work</p>
<p>Hi, I just don't quite get how you did this. Could you provide written instructions, by chance? Thank you.</p>
the heat shock going from hot heated by the string on fire. to cold under the tap causes the glass to fracture cleanly along the heat line.
<p>Thank you for the clarification, I'm going to try this.</p>

About This Instructable




More by Builder971:Fire Bullet water proof bottle from a beer bottle. How To Make A Drinking Glass From A Beer Bottle 
Add instructable to: