Introduction: How to Make a Fishtail Rubber Band Bracelet

Picture of How to Make a Fishtail Rubber Band Bracelet

You will need:
30-40 bands according to your wrist size
A loom
A hook
A c or s clip

*you can use two fingers instead of a loom*

Step 1: Starting Your Bracelet

Picture of Starting Your Bracelet

Twist your first band

Step 2:

Picture of

Place two more bands on top of the twisted band.

Step 3: Looping the Bands

Picture of Looping the Bands

Loop the bottom twisted band over the other two bands.

Step 4:

Picture of

Do this to the other side.

Step 5:

Picture of

Add another band on top.

Step 6:

Picture of

Loop the bottom band.

Repeat this step until you reach the end of your bracelet.

Step 7:

Picture of

Apply your clip to the band that was looped.

Step 8:

Picture of

Take the loose end off your bracelet and connect it to the other side.

Step 9:

Picture of

You are done! Leave a comment telling what bracelet I should do next! Hope you enjoyed! Bye!


About This Instructable




Bio: Hey everyone! I am an alien who loves rainbow loom, wwe, one direction, alpaca, and MUSTACHES! Check out some of my instructibles. Thanks for checking ... More »
More by liqueloves1d:How To Make A Fishtail Rubber Band BraceletHow To Make A Starburst Rubber Band BraceletRainbow Loom Chain Bracelet
Add instructable to: