Print PDF
Favorite
Email
Step 4Molding
This step features pictures from the pendant that was a failure! Because I took pictures of that whole process too. Here's how you make the mold:
Step one: Make a box out of foamboard, and make sure all of the cracks are sealed with hot glue.
Step two: Place the pendant flat side down at the bottom of the box.
Step three: Mix equal parts of the silicone rubber parts A & B (or follow the instructions included if they are different)
Step four: Try to minimize the amount of bubbles, and then pour the rubber over your pendant.
Step five: Wait an hour or so, and then split apart the sides of your mold box. Carefully pull out the clay pendant.
Step one: Make a box out of foamboard, and make sure all of the cracks are sealed with hot glue.
Step two: Place the pendant flat side down at the bottom of the box.
Step three: Mix equal parts of the silicone rubber parts A & B (or follow the instructions included if they are different)
Step four: Try to minimize the amount of bubbles, and then pour the rubber over your pendant.
Step five: Wait an hour or so, and then split apart the sides of your mold box. Carefully pull out the clay pendant.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
