Introduction: How to Make a Starburst Bracelet on the Loom!
Placing the bands:
Placing the bands
Go all the way up until your loom looks like this:
Then you do the other side:
Placing the burst bands:
Then you do the same thing going clockwise.
And you do the same thing all the way up.
Flip the Loom around.
Placing the capping bands, make a figure 8 and fold it back upon it's self.
Actually placing the capping bands.
Going all the way up.
Grab the top rubber band and loop it.
This is what it should look like when you are done loop ing one starburst
When you are done looping all the starburst it should look like this.
Now lets loop the border bands. Don't worry, this part isn't near as hard as the part you just did. ;) first you get one of the side bands and loop it to it's original peg.
Any you go all the way up until it looks like this.
Then you do the other side.
Tie a rubber band on the end.
Pull it off the loom.
Give it a clip.
We have a be nice policy.
Please be positive and constructive.