Introduction: How to Make a Starburst Bracelet on the Loom!

Step 1:

Placing the bands:

Step 2:

Placing the bands

Step 3:

Go all the way up until your loom looks like this:

Step 4:

Then you do the other side:

Step 5:

Placing the burst bands:

Step 6:

Then you do the same thing going clockwise.

Step 7:

And you do the same thing all the way up.

Step 8:

Flip the Loom around.

Step 9:

Placing the capping bands, make a figure 8 and fold it back upon it's self.

Step 10:

Actually placing the capping bands.

Step 11:

Going all the way up.

Step 12:

Looping

Step 13:

Grab the top rubber band and loop it.

Step 14:

This is what it should look like when you are done loop ing one starburst

Step 15:

When you are done looping all the starburst it should look like this.

Step 16:

Now lets loop the border bands. Don't worry, this part isn't near as hard as the part you just did. ;) first you get one of the side bands and loop it to it's original peg.

Step 17:

Any you go all the way up until it looks like this.

Step 18:

Then you do the other side.

Step 19:

Tie a rubber band on the end.

Step 20:

Pull it off the loom.

Step 21:

Give it a clip.