Print PDF
Favorite
Email
Step 3The Holder
This is how you build the holder. I hope you saved that little strip!
Photo 1: This is the strip.
Photo 2: Wrap the strip around the cup.
Photo 3: Now tighten as needed, you want a tight fit.
Photo 4: Put on the tape.
Photo 5: Finished holder. Try to keep it and reuse it.
Photo 1: This is the strip.
Photo 2: Wrap the strip around the cup.
Photo 3: Now tighten as needed, you want a tight fit.
Photo 4: Put on the tape.
Photo 5: Finished holder. Try to keep it and reuse it.
| « Previous Step | Download PDFView All Steps | Next Step » |
2
comments
|
Add Comment
|
Dec 17, 2010. 4:06 PMHALOPLAYER101
says:
Hey Iknow a better way!Do the same step`s but when yourn done,cut a little strip that fit`s under it. Put tape on it you`ll be sure for so it dose`nt leak!(I Used Construction Paper)
Reply
Aug 26, 2009. 7:05 PMspiralofhope
says:
You don't need a piece of tape for the last step. Here's how I did it: - Take your long strip of paper and place it down so it's landscape in front of you. - take the bottom edge and fold it roughly into the middle - take the top edge and fold it so that it's roughly near the bottom - Take the left edge, and fold one corner up, so you made a triangle out of that edge - Pick the page up, and curl the edges together - feed the triangled edge into the opening on the other side You could also pinch a fold or two in your ring, to help it not unfurl so much. It's not as good as tape for resisting weight and water, but it works.
Reply
 |
Add Comment
|
