Instructables
loading
loading
Picture of How To Make The Bear Paper Airplane
The Bear is an interesting paper airplane with a tri-tail configuration.





TAA USAF Designation: F84-1
 
Remove these adsRemove these ads by Signing Up

Step 1: Materials

Picture of Materials
Required:
1 piece of 8.5 by 11 inch Paper
Tape
Scissors
Optional:
Pencil

Step 2: Begin Folding

Picture of Begin Folding
Instructables 8 013.jpg
Take your paper and fold it along its length. 

Step 3: Continue

Picture of Continue
Instructables 8 015.jpg
Instructables 8 016.jpg
Fold the corners into the center. Then pull the nose back and down.

Step 4: Security Fold

Picture of Security Fold
Instructables 8 018.jpg
Instructables 8 019.jpg
Fold the corners into the center, though not all the way. Repeat on the other side and then fold the small flap below them up over it.

Step 5: Fold The Wings

Picture of Fold The Wings
Instructables 8 001.jpg
Instructables 8 002.jpg
Instructables 8 003.jpg
From their previous position fold the airplane in half. Then fold the wings approximately 3/4 in. up from the bottom. Repeat on the other side. 

Step 6: Cut The Vertical Stabilizers

Picture of Cut The Vertical Stabilizers
Instructables 8 006.jpg
Instructables 8 007.jpg
Instructables 8 010.jpg
Cut the 3 vertical stabilizers out of the wing and fuselage. Each should be 3/4 in. tall. Allign them pefectly with the back of the wing.

Step 7: Tape The Airplane

Picture of Tape The Airplane
Instructables 8 009.jpg
Instructables 8 010.jpg
Tape the plane's front and back together in the cited places in the picture.

Step 8: Flight

Picture of Flight
The Bear is a slow dart and should be launched like a dart, pitched down.