Instructables

Step 1: Materials

Picture of Materials
Required:
1 Piece of 8.5 by 11 inch Paper
Tape
Optional:
Pencil
1 Piece of 4.25 by 5.5 inch Paper (for the parasite aircraft)
Scissors (for modifications to the parasite aircraft)

Step 2: Begin Folding

Picture of Begin Folding
Instructables 17 003.jpg
Instructables 17 004.jpg
Instructables 17 005.jpg
Instructables 17 006.jpg
Take your paper and fold it along its length. Then pull the corners in and fold them into the center. Then open the paper.

Step 3: Continue Folding

Picture of Continue Folding
Instructables 17 008.jpg
Instructables 17 009.jpg
Instructables 17 010.jpg
Instructables 17 011.jpg
Pull the top down along the bottom of the previous corner folds. Pull the corners in, however not as much as before, making the nose blunt. Repeat on the other side. Then pull the triangle up towards the nose over the two folds. Then flip the paper over to the "clean" side. 

Step 4: Gull Folding

Picture of Gull Folding
Instructables 17 013.jpg
Instructables 17 014.jpg
Instructables 17 015.jpg
Pull your paper in once again on each side into the center, then fold it in half again after releasing it to it's previous shape.

Step 8: Choosing and Building Your Parasite Aircraft

Constructing your parasite aircraft begins with your piece of 4.25 by 5.5 inch paper and choosing a full scale design. This design is then scaled down to it's smaller size.

My usual choices for this role are either a small Kingcobra (http://www.instructables.com/id/How-To-Make-The-Kingcobra-Paper-Airplane/) (as pictured in the #1 slot), or a small Super Dart (http://www.instructables.com/id/How-To-Make-The-Super-Dart-Paper-Airplane/) (as pictured in the #2 slot).

 

Step 9: Flight (With A Parasite Aircraft)

With a parasite aircraft on it's back, the Courier Dart is slower, but at a certain moderate speed, will deploy it's parasite counterpart in mid air.