Introduction: How to Make the Destroyer Dart Paper Airplane

Picture of How to Make the Destroyer Dart Paper Airplane

So named for its Wild Weasel role, the Destroyer Dart is also a good interceptor.

TAA USAF Designation: F105-1 

Step 1: Materials

Picture of Materials

1 piece of 8.5 by 11 inch Paper

Step 2: X Fold to Start

Picture of X Fold to Start

Fold the paper from one corner to the other side and repeat on the same side.

Step 3: Cover Folds

Picture of Cover Folds

Pull the top down over itself and fold it as shown in the pictures.

Step 4: Preparation for the Security Fold

Picture of Preparation for the Security Fold

Pull the corner into the center as pictured. Repeat on the other side, then fold the plane in half.

Step 5: Security Fold

Picture of Security Fold

Along the airfoil line, fold the two flaps underneath the line.

Step 6: Fold the Wings

Picture of Fold the Wings

Fold the airplane in half along it's center. Then fold the wing down along the security fold. Repeat on the other side of the aircraft.

Step 7: Tape Your Aircraft

Picture of Tape Your Aircraft

Tape along the bottom of the security fold, the back of the security fold and the rear of the airplane.

Step 8: Flight

Picture of Flight

Your Destroyer Dart is now ready for flight. Enjoy!


About This Instructable




Bio: I am someone who mass produces paper airplanes and am always developing new designs. I post regular updates on Twitter and Google+. Follow me there ... More »
More by OrigamiAirEnforcer:How to Make the HyperAttacker Paper AirplaneHow to Make the StarRanger Paper AirplaneHow to Make the Aerowing Paper Airplane
Add instructable to: