Instructables

Step 1: Materials

Picture of Materials
Required:
1 Piece of 8.5 by 11 inch Paper
Tape
Optional:
Pencil

Step 2: Length And Width Folding

Picture of Length And Width Folding
121_3312.JPG
121_3313.JPG
121_3314.JPG
Fold the paper along its width. Then fold it along its length. Then open the paper. You should now have a paper divided into fourths.

Step 3: Corner Folding

Picture of Corner Folding
121_3316.JPG
121_3317.JPG
Fold the corners of your paper to the mid-length folds on the opposite side of the paper.

Step 4: Cover And Canard Preparation Folding

Picture of Cover And Canard Preparation Folding
121_3319.JPG
121_3320.JPG
121_3321.JPG
121_3322.JPG
Repeat the corner folding as before, but make a crease at the length fold up along it. Fold the other side on top of it, then repeat the creasing on that side too. After both sides are creased, squash the paper down. 

Step 5: Canard, Wing And Landing Gear Folding

Fold the top of the diamond at the front down onto its other half. Then fold the aircraft in half along its length. To make the wings, fold them down about 1 inch up from the center, parallel to the center fold.  To make the landing gear, fold the tips of the canards to then point where another layer of paper emerges from the wing root.  

Step 6: Winglet Folding

Picture of Winglet Folding
121_3331.JPG
121_3332.JPG
While your aircraft's wings are each folded down, fold up the winglets. From about 0.75 inches in from the wingtip, fold up the winglets. Do this on each side. 

Step 7: Taping Your Fury

To properly complete your Fury, tape the front and back of the fuselage together and the canards to the bottom of the wing.