Introduction: How to Make the MZ3P5
This gun is a whopper. It has a scope and a place to put the bullets. Let's go!
Step 1: Materials
You will need:
Step 2: Binder Needs Cuts
Cut the thick red line on the left
Step 3: The 2 Main Tubes
Roll the paper the long way and tape it then cut it
Step 4: The Slit and Strips
Cut a slit, then get binder paper and cut it 6 lines
Step 5: The Round of Handles
Roll the little bullets and tape them. Get another piece of binder paper and roll it the long way and tight. Tape all the bullets together, and tape. I taped my handle fancy.
Step 6: The Trigger
Cut the tight tube and use the smallest piece, connect it to the handle.
Step 7: The Guns Main Cocker
Cut a piece of binder paper and wrap it around the gun. Make it steady and tape the cocker.
Step 8: Handle It Toghether
Tape the handle to the cocker, and tape the tubes together.
Step 9: Hold On!
Make another handle but straight, (if you done it my way) Tape it to the gun.
Step 10: The 360 Noscope
Pull this out and cut the tube to make the no scope. Then tape the scope on cocker
Step 11: Done!
Now your done! Go on if you want to mod your gun!
Step 12: Mod Your Gun
1. Roll up one piece of paper and flatten it, then do what the pic says. That's all!
Step 13: Shoot and Enjoy
Enjoy! Flick the gun back