How do you make a back wall? ly! package of what piepschuim, flag adhesive and needle painting.
Step 1: Measure the dimensions
you firstly generally measure the half-measures of your terrarium are the binnekant what takes into account smaller therefore that you a couple mm of finished must obtain that draws you there on the piepschuim and cuts out it. I use generally piepschuim of approximately 2cm.
Step 2: Look how widely and long
look how widely and long you want it then makes you a gleuf of how widely you want it in the back wall there do you tegelijm in lubricate and put you the plattotje then you can along the they side of plattotjes also with flag adhesive finishing. plattotjes you can form beautiful by burning ofzo the edges with a lighter round pay attention, however, to that plattotjes not too dense or against the lamp sit at the table!
Step 3: Paint
if everything are dried you can paint starting/spout! pay attention, however, to that somigge painting toxic substances continues deliver! sometimes painting bites also by the piepschuim gone, which I have had already once therefore pay attention then also good! if you cannot it spread trusted you the back wall with tegelijm and then firstly let dry then is possible you without some problem starting with paintings! this gives frequently also a nice impact.
Step 4: Finnis
the back wall to place in the terrarium is rather easy. you push him and generally continue ie then immediately be stuck. the they sides can you finish with kit, so that krekels or other insecten cannot crawl behind the back wall!