How to Assemble and Install an AXISdapter

Step 4 Screw Terminals

If your kit included screw terminals, now is the time to install them. Once again, they go on the same side of the board as the white silkscreen lettering. If you opted to not get screw terminals, go ahead and skip this step.

Each screw terminal has an exposed side the wires are inserted into. Place all of the screw terminals on the board making certain that the wire entry points face outside of the board. Flip the board over so the board rests on the screw terminals, double checking that they are all oriented properly. Solder one leg of each terminal to the board to hold the rest in place, then continue soldering the remaining legs until finished.