Remove these ads by
Flag this comment as:
Not NiceInappropriateSpam
3 Simple Ways to Share What You Make
With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
Create on the go:
With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
Do you need a way to hide something of a bigger size, like bigger than would fit inside a hollow book? Here is another idea using books and a book ...
Supplies: A sturdy cardboard (mine was a box that held dish washer tablets) Books (enough to cover one side of the box) White glue E-6000 glue ...
If needed remove the flaps on the box with the box knife. Make sure that you have books enough to cover the front of the box.
Using the blue tape, wrap a layer around the book close to the spine. Do this to all the books.
Set the table saw blade at 2 inches. The goal is to cut 2 inches of the spine, off from each book.
We have a fine blade on the saw. We put the blade up as far as it would go,
but we had to turn more than one book over, and run it through from the other direction, removing the spine from the body of the book. Recycle the ...
Don’t remove the tape yet.
Apply white glue to the cut end of papers, to make them a solid mass. Let it dry.
If your box has a glossy surface, sand it to make it less glossy, thus allowing the glue to stick to it. Remove the blue tape.
Put some E-6000 glue on the sanded side of the box. Place the cut end of a book spine on the glue, lining the bottom and side up with the bottom an...
Let it dry, up to 24 hours, it takes that long for E-6000 to cure.
Now stick it in your book case, high enough that you can’t see down into the box, and put books beside it, on both sides. It is ready to keep your ...
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »