I was bored and decided to make a modded computer case. I did all of this by myself with the help from a few people for cutting the case and plexiglass. I hope this helps anyone wanting to mod their computer, but are a little skeptical. This is my first instructable so please comment and tell me how I did. I am only 15 so it may not look professional.
Plexiglass - about 8 bucks (Local hardware store)
Screws $1.00 (Local hardware store)
Jigsaw (You can buy one online if you don't have one)
Drill (I had one)
Electrical Tape (pretty cheap at target)
Cold Cathodes, Lazer LEDs, and a LED Fan - with tax and shipping, $19.97 (www.jab-tech.com)
A computer hopefully and some hard work and time. :D
Thanks for checking it out and I hope you enjoy.
Step 1: Start making the window...
The First thing you need to do is measure the case and find a good size for the window. Then decide how big you want it to be, I chose 10 x 9 in. for my window. I went to my local Ace Hardware store and got a piece of plexiglass cut right there for me.
Step 2: Who cut the case???
Now you need to cut your case to fit your window. Make sure you outline your window with pencil and then take a ruler and go about 1/2 inch in the outline of your window so you have room to drill holes to attach it to the case. Then drill the holes and place screws in with nuts on the other side to keep it in place.
Step 3: Add Your case fan if you have it.
I had a fan with a direct port to my cpu so I needed to add holes for that. If you look at the pictures, I drilled holes for ventilation, but decided to use mesh afterwards.