Instructables
Picture of How to Make a Simple Pillow Case
All it takes is about a yard of fabric to make a cute, custom pillow case.  My sewing skills are very lacking, but this is all straight lines, so it is super easy.  All you need is:
Scissors
Ruler
Thread
Fabric (I used about a yard of one, and about a quarter yard of another.
 
Remove these adsRemove these ads by Signing Up

Step 1: Make a "Pattern"

Picture of Make a
12272010.jpg
10232010 006.jpg
12272010 113.jpg
Using a pillowcase you already have, measure the rectangle to find how big you need to make yours.  Mine was about 20 inches wide and 30 inches long.  Afterwards I googled the "standard pillowcase size" and found that most are about 22 inches by 32 inches. 
I decided I wanted a little bit of contrasting fabri on the edge of mine, so I decided 5 inches of the 30 were enough.  I added 1 inch seem alowance on all seems, and an extra 3 inches to fold over on the open edges, since that seems to be standard for all pillowcases.  So, I came to decide, I need 2 pieces of the "main" fabric, 22 inches by 27", and 2 pieces of the "accent" fabric that were 22 inches by 9 inches.

Step 2: Cut Fabric

Picture of Cut Fabric
10232010 006.jpg
I cut the fabric, 2 pieces from each.  The Bill and Ted fabric is my "main" design, and the green is the "accent."  Because the flash went off in some pictures, and not in others, the color seems to differ from blue to green, but the solid fabric is all the same.

Step 3: Pin the Fabric

Picture of Pin the Fabric
12272010 114.jpg
Right sides together, pin one of the "main" fabrics" to one of the "accent" fabrics along the side that is 22 inches. 

Repeat with the other two pieces of fabric

Step 4: Sew

Picture of Sew
Sew along the pinned line on each pair of fabric.

Step 5: Make the Opening Hem

Picture of Make the Opening Hem
12272010 118.jpg
Fold the "accent" fabric down 3 inches and pin along the line.  Repeat for the other panel.  Sew along the pinned line on both panels.

Step 6: Pin the Panels Together

Picture of Pin the Panels Together
Put the panels right sides together with the blocks of fabric matching.  Starting at one corner, pin around the edges, leaving the top part (the part with the 3 inch hem) open. 
imamathguy2 years ago
Looks great. Where in the world did you find the B&T fabric?
jnifrwebb (author)  imamathguy2 years ago
Spoonflower.Com
The Bill and Ted series is like my 3rd favorite time traveling movies.
Marysia_Too2 years ago
Hi...just a friendly suggestion. Since most fabric is 44 inches, all you need to do is use 3/4 yard (27 inches long) of a 44" wide fabric - then fold it in half selvedge to selvedge. No need to trace a pattern piece, and one side of the case is already closed. All you need to do is then is put on the "accent fabric" or cuff as I call them. Then sew across the bottom and up the open side. Done!