Introduction: How to Make an Orange Pi Power Adapter

I got a $20 orange pi from here, which was a very good deal even without a cord, i didn't realize that it didn't come with a power cord, so i made one.

Step 1: I Wanted a USB Connector, So That's What I Made

The plug on the pi is a 5mm plug and i wanted a USB plug

Step 2: Find a 5mm Plug and a Female Usb Port

Solder the two together 5v to 5v and gnd to gnd. MAKE SURE THE POLARITY IS RIGHT!!!!!

Step 3: Connect It Up and Your Done

Your orange pi should boot up no problem

Comments

author
Droxz (author)2016-10-30

Nice one, but does your USB hub supply 2amp for the Orange pi?

author
Funguypro (author)Droxz2016-10-30

Yes it does

About This Instructable

4,418views

20favorites

License:

Bio: I like to create new things! I'm very interested in IOT and just Internet Stuff. I am not responsible for any injury or deaths ... More »
More by Funguypro:3D Print Your House!!!!!DIY Raspberry Pi Indoor Outdoor WebcamSee Through Buildings With a Drone
Add instructable to: