Step 4: Putting the Blade to the Bracelet
Now, make two fastener sized slits towards the bottom of the blade, one closer to the bottom and one above it. Insert two fasteners and fold the top one down, but not the bottom.
Now, make another slit in the bottom of the tubes (in the center). Insert the unfolded fastener on the blade into the slit. This will hold it in place while you mess with it/attach rubber bands.
Next, take two rubber bands and string them from the two fasteners on the tubes to the upper fastener on the blade. The shorter/tighter they are, the better. Now take a piece of duct tape and tape the fastener on the blade so the rubber bands won't fall off it.