How to Replace Toyota Corolla (1998-2002) Gauge Lights

Tutorial on how to replace or change the color of the gauge lights in your car.

Note: These instructions are specific to a 1998-2002 Toyota Corolla. However, the same basic principle applies to most car models.

Equipment:
Phillips screwdriver
Replacement bulb kit (color of your choice)

Step 1: Remove the Front Panel

Unscrew the two screws located above the speedometer on the underside of the overhang. Slide the panel out.

Step 2: Unfasten the Gauge Cluster

Note: The gauge cluster is the panel that has the speedometer and other gauges.

Unscrew the three screws holding the gauge cluster in place (one above and two below as indicated in the picture). Pull the gauge cluster out.

WARNING: The gauge cluster panel is connected to numerous wires. Pull it out slowly. Be careful not to destroy the wiring. You will only be able to pull it out approximately 12 inches.

Step 3: Remove the Bulb Sockets

Remove the three big bulb sockets by rotating them counterclockwise approximately 30 degrees, then pull out.

Step 4: Replace the Bulbs

Note: This is the fun part. You can change the color of your gauge lights by replacing the factory bulbs with bulbs of the color of your choice. If you just wish to replace a burnt out bulb and not the color, use the standard replacement bulbs.

Remove the bulbs from the sockets by pulling them straight out. Place the new bulbs in the old sockets exactly the opposite way you pulled them apart. Push the new bulb and socket combinations back into the motherboard and twist it 30 degrees clockwise.