Print PDF
Favorite
Email
Step 8Attach Reflector Assembly to Glass
Behind the LCD and polarizing sheets - you'll find a pane of glass, about 1cm thick. The reflector assembly straddles this glass. So, what you need to do is clip the reflector assembly on to this glass AND do so in a way that won't break the bulb (that is, as even as possible).
In my case, I had an extra issue. The plastic trim was not removable without a lot of sensitive disassembly. Therefore, I couldn't directly attach my reflector assembly. So, I pulled up on the plastic case, attached the reflector about an inch away from the target and slid it over into place.
In my case, I had an extra issue. The plastic trim was not removable without a lot of sensitive disassembly. Therefore, I couldn't directly attach my reflector assembly. So, I pulled up on the plastic case, attached the reflector about an inch away from the target and slid it over into place.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
