I know that there are other instructables on the art of book binding but this project is meant to be a simple quick project that will give a very acceptable finish and a book that looks like it has been professional made, yet without the need for any special equipment.
All you will need is:
minimum really is about 32 A4 or US Letter sized sheets, to make a half A4 (half US Letter sized book), although small books can be made as can ones with more pages. You can use tracing paper, thick or thin paper and of course colored or even preprinted or written on paper.
You will need PVA (Elmer's White glue) or a rubber fabric adhesive (in the UK that is called Copydex, perhaps someone could tell me what it's called in the US), (a glue gun if you have it, would help with one of the stages, but is not mandatory)
Some stiff cardboard or corrugated (fluted) cardboard
Some fabric or leather
Any old stuff will do for the cover. I have used the fabric from some old pairs of trousers that were being thrown out (actually nothing gets thrown out in my house, just put to one side for later use). But you could use a bit of leather, some old curtains, cushion covers...etc etc, I'm sure you get the idea.
Step 1: Stack your paper neatly in (at least 4) piles of 8 sheets
Your book should have at least 4 or these 8 sheet folios which will therefore make 128 pages. (apologies to all the maths wizards out there).
You can use just plain paper or paper upon which you have already printed a header and footer (remember to get this the right way round and remember that there will be 4 headers and four footers per sheet of paper.
If you want to mix in different papers then remember that they will appear further into the book as well. (don't worry, this all becomes obvious as we go through the project).