Print PDF
Favorite
Email
Step 11Make the seed baffles
Cut out a 1/3 section from each of the 4 PVC connectors. These will be the baffles that prevent seed from falling out of the feed holes.
| « Previous Step | Download PDFView All Steps | Next Step » |
2
comments
|
Add Comment
|
Aug 6, 2009. 9:11 AMpops44
says:
Maybe that didn't come out right....Should they be shortened?
Reply
3
Aug 10, 2009. 10:35 PMbillr (author)
says:
pops44, How long are the feed tubes/baffles? Mine are 1.5 inches in length, which leaves plenty of room inside the 4" diameter tube for the seeds to reach the bottom plate. Did you cut out the bottom 1/3 section of the baffles? - Billr
Reply
Aug 12, 2009. 8:08 AMpops44
says:
Yes, I did cut the tubes so they are shorter now, and there seems to be plenty of room inside. Apparently, we both used different length of tube...Now just waiting for the birds. Also, I was concerned about the seeds falling out of the feeder when the birds begin eating. Thanks..Tom
Reply
Aug 5, 2009. 9:01 AMpops44
says:
I noticed that when the feed tubes are inserted, there isn't very much room for the seed to fall through on the inside of feeder, is this correct or should the connectors be cut in half length wise to leave more room on the inside?
Reply
 |
Add Comment
|
