Print PDF
Favorite
Email
Step 5Adding the electronics
In this final step the electronics are added.
These steps are also described in the Tagtool Suitcase Instructable - have a look there for additional explanations.
Picture 1
Connection Plan
This shows how to connect the Arduino to the faders and the pushbutton.
Note the 10K Ohm Resistor that is added to the connection to the pushbutton.
Picture 2
Pull off the plastic bits off the Arduino contacts so we can directly solder the cables to them.
Picture 3
Screw on the faders & the button to the top panel.
Picture 4-5
Solder the wires to the connectors according to the schematics of Picture 1. Use plenty of shrink tubing.
Nearly finished...
These steps are also described in the Tagtool Suitcase Instructable - have a look there for additional explanations.
Picture 1
Connection Plan
This shows how to connect the Arduino to the faders and the pushbutton.
Note the 10K Ohm Resistor that is added to the connection to the pushbutton.
Picture 2
Pull off the plastic bits off the Arduino contacts so we can directly solder the cables to them.
Picture 3
Screw on the faders & the button to the top panel.
Picture 4-5
Solder the wires to the connectors according to the schematics of Picture 1. Use plenty of shrink tubing.
Nearly finished...
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
