Introduction: How to Do a Coupler Mod to Your Nerf Nite Finder

Hey Everyone! This video is on doing a coupler mod to your Nerf Nitefinder so that you can change out barrels! I'll probably upload a video on how to make a speedloader soon. Links to my other Nerf Nitefinder mods: (AR removal, barrel replacement, vaccum load, spring stretch)

Thanks for watching. Please comment, rate, and subscribe! Also if you have any questions, feel free to ask, i'll probably get back to you within a day or two. Lastly, please visit my website at


blueblobbs (author)2011-06-15

do you have any recon cs 6 mods

Pizzapie500 (author)blueblobbs2011-06-16

I did do a recon mod, but i'll have to see if I have the pictures. I have finals for the next two weeks so I can't do it now.

blueblobbs (author)Pizzapie5002011-06-16

ok i`ll wait

kobes (author)2011-04-20

what i bought was the inside, sorry

kobes (author)2011-04-20

is that half inch diameter on the inside or outside of the pipe? i bought some half inch cpvc and a coupler from bunnings and it was the diameter of the outside, the darts could slip right through and it didnt fit the shell

About This Instructable




Bio: Hey everyone! I go to this site very often and in 12 months I have had 600 replies! I like knex, nerf guns, websites, video ... More »
More by Pizzapie500:How to do a Coupler Mod to your Nerf Nite FinderHow to Make a Two Dart Speedloader for your Nerf GunsHow to Mod your Nerf NiteFinder: Reinforce and New Spring
Add instructable to: