This can be kind of a like a gift for your friend that really likes Instructables. I might do this for my friend Dylan, I got him into Instructables.
I hope you like this Instructable!
Step 1: Get your materials.
1 Soldering iron (NOT a soldering gun.)
The place you desire to have your Instructables Robot.
A mechanical pencil, or something that has the plastic tip.
1 Pen (optional)
A picture of Instructables Robot
Step 2: Tracing the robot.
Get the pencil, and MAKE SURE there is NO LEAD STICKING OUT.
You just need the plastic thing.
Now, trace over Instructables Robot quite hard, but not hard enough to rip the paper.
Step 3: Re-tracing.
You can see the Instructables Robot quite good, but retrace it again (without the paper) a little bit harder to make it stick out more.
Step 4: Get the soldering iron! (Not gun!)
Cover up your fire alarm, then get to work.
Start tracing over the Instructables Robot with the soldering iron, but not too deep, and it should come out like the picture below.
Step 5: OPTIONAL: Marker Tracing.
You can trace over the Instructables Robot with a very inky pen. Before you do that, scrape out the inside tracing of the Robot, or wood will get on your pen.
It should look like the bottom picture below.
Step 6: You're done!