Introduction: How to Get an Uninterrupted Power Supply of 5.3v From a Mobile Phone Charger A.k.a How to Make a Adapter of 5.3v?

If you are having a mobile phone charger you can easily make a adapter supplying a low voltage.I am having a NOKIA AC-2N charger and it's output is approximately around 5.3v.You can use any mobile phone charger but first see it's output voltage.At first, plug in the charger.

Step 1: Step 1

Attach a paper clip over the socket as shown.Connect a wire.This is your negative terminal supplying 5.3v.

Step 2: Step 2

Insert a pin inside the socket ,this makes your positive terminal. Be careful about inserting the pin make it as soft as you can.Run any device for testing your new adapter.

Step 3: Enjoy..........

Enjoy with your new adapter but avoid short-circuiting the wires for it will reduce the charger's life.


Malkaris (author)2015-05-21

How is it uninterrupted?

luckysac916 (author)2012-02-04

could always just buy a female connector (or hack your old phone for free) connect to the needy..that's what I do.


But that's my mom's charger, so I decided to take the power without doing any 'hack' thing!


Yeah female connectors are always helpful.Currently, I am running a small pocket fan that I made of a d.c. motor with a female connector!

Ranie-K (author)2011-10-13

Why not just cut the wire and remove some of the insulation?


bcoz in some chargers da wire is separated by a thin nylon strip n wth dis u dont hve to 'destroy' ur charger up!!!!!!!!!!!!!!!

About This Instructable




Bio: I'm a rockin n dashin guy who's always on the hunt for electronics,guns,games,Alternative Rock music and of course the NERF ...
More by anubhavtalukdar007:How to get an uninterrupted power supply of 5.3v from a mobile phone charger a.k.a how to make a adapter of 5.3v?
Add instructable to: