Print PDF
Favorite
Email
Step 4Now for the stand
cut a long piece of wire from the hanger
wrap the end of it it around the screw on the bulb
about two inches from the bulb bend the wire down 90 degrees
five or six inches from that bend bend it to be horizontal then two inches from that bend it right 90 degrees
staple or duct tape it to the board
wrap the end of it it around the screw on the bulb
about two inches from the bulb bend the wire down 90 degrees
five or six inches from that bend bend it to be horizontal then two inches from that bend it right 90 degrees
staple or duct tape it to the board
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
