Hello everyone this is how to make a Coka Cola robot from recyclables so lets get started shall we?
down below you shall see the tools/materials used to make this object if you don't have these objects sent me a message or comment about it and i will try and find a substitute for it, o.k?
these objects are:
1. Permanent marker
2. silicon gun
3. Driver drill
4. Plyers
5. Stanly knife
6. Silicon
7. Sticky tape
8. 2 cans of finished soft drink
9. Battery
10. Colored wire
11. Burnt out light bulb
12. Screws
down below you shall see the tools/materials used to make this object if you don't have these objects sent me a message or comment about it and i will try and find a substitute for it, o.k?
these objects are:
1. Permanent marker
2. silicon gun
3. Driver drill
4. Plyers
5. Stanly knife
6. Silicon
7. Sticky tape
8. 2 cans of finished soft drink
9. Battery
10. Colored wire
11. Burnt out light bulb
12. Screws
Remove these ads by
Signing UpStep 1: Lets get started
First you should cut out the head with the the Stanley knife WARNING: be careful the aluminum can be sharp when cut up don't cut yourself. Next cut a rectangular hole in the can (with the Stanley knife)for the later made battery and light bulb to go then fit and sticky tape the hatch to the can so you can open and close the hatch.
Visit Our Store »
Go Pro Today »
good idea......!!!!!
:)
Sunshiine
So, would you mind clarifying what you mean by "BTW what the?" Ideally, you would do that by writing a complete sentence, with English words properly spelled, but that might be asking too much.
(you should put a picture of your finished robot as the first intro picture to give people an idea on what you're sharing)