Hello everyone this is how to make a Coka Cola robot from recyclables so lets get started shall we?
down below you shall see the tools/materials used to make this object if you don't have these objects sent me a message or comment about it and i will try and find a substitute for it, o.k?
these objects are:
1. Permanent marker
2. silicon gun
3. Driver drill
5. Stanly knife
7. Sticky tape
8. 2 cans of finished soft drink
10. Colored wire
11. Burnt out light bulb
Step 1: Lets get started
First you should cut out the head with the the Stanley knife WARNING: be careful the aluminum can be sharp when cut up don't cut yourself. Next cut a rectangular hole in the can (with the Stanley knife)for the later made battery and light bulb to go then fit and sticky tape the hatch to the can so you can open and close the hatch.
Step 2: Ready for the next couple of steps?
Now you have to strip the colored wires(with the Plyers) so the you can see the bronze wires underneath then break the bronze wires with the Plyers and after that you have to rap the bronze wires around the battery and then silicon them to the battery then you silicon the battery to the light bulb and wait for them to dry. p.s make sure you keep it levitated because it makes it easier to move it.
Step 3: Putting the feet on
o.k now you have to take the caps lids and silicon them to the bottom of the can so i kind of looks like a little penguin if i does good job =)