Step 4: Wire the circuit on the bread board.
Wire the circuit on the borad. It is a quite simple circuit. Check the circuit diagram.
Analog input is for the microphone, and Digital Output(PWM) for the servo motor.
The mic module needs the power at Vcc(3.3V) from arduino's Vcc pin.
The servo motor requires 5 to 6V to be driven, so you connect the battery power to it.
What is the capacitor into VCC and GND? Because I have been suffered from the noise of microphone. The combination of the ECM module by Sparkfun and Arduino seems to be unstable. For instance, when I wrote serial communication code to monitor A/D value, it cause enormous noise and the A/D value keeps high. So the capacitor is to ease my mind.
Analog input is for the microphone, and Digital Output(PWM) for the servo motor.
The mic module needs the power at Vcc(3.3V) from arduino's Vcc pin.
The servo motor requires 5 to 6V to be driven, so you connect the battery power to it.
What is the capacitor into VCC and GND? Because I have been suffered from the noise of microphone. The combination of the ECM module by Sparkfun and Arduino seems to be unstable. For instance, when I wrote serial communication code to monitor A/D value, it cause enormous noise and the A/D value keeps high. So the capacitor is to ease my mind.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
13
McMchriis
says:
Apr 23, 2012. 9:14 AMReply
Where I can GEt The Arduino Control!!!
10
omnibot
in reply to Apr 23, 2012. 9:56 AMReply
Here is a list of distributors: http://arduino.cc/en/Main/Buy
13
McMchriis
in reply to Apr 26, 2012. 5:37 AMReply
Thankss!!!
Visit Our Store »
Go Pro Today »
